Re: [DDL-ML] win-erddcd

[Michael Gräfe <mgrafe@snafu.de>]

Robert Nieuwland schrieb:

> Hallo Michael
>
> I have tried version 0.2 of win-erddcd. Only it does not work.
> - Power On/Off works but power keeps falling away and comming back at
> regular intervals.
> -I have the same problem with the switch decoders as with Erddcd.
>  The old marklin K83 work. The lenz decoders work so now and then.
>  Trains I cannot run because of the power drop outs.
>  They accept the speed commands as far as I could have tested it.
>
> I have to write this in english. My german is not good enough for writing. I
> can read it without any problem.
>
> Best regards Rob Nieuwland.

Rob, thank you for your report!
I have also observed that the loco performance decreased since I implemented the
DCC protocol. However, I use Marklin-decoders only. Apparently I have to buy
other decoders in order to test the win-erddcd properly.
Today I have recorded the erddcd output with a fast AD-card. Maybe this will
help to improve the timing. When I have analyzed the ouput signal I might change
the timing intervals between the packets. However, you are invited to improve
the code yourself.

Yours Michael Gräfe